Course Description
Module 1: How to Choose an Architect
Module 2: Building Codes. Best Practices. Lack of Knowledge and Apathy
Module 3: Roof Design
Module 4: Costs of Building a Mold-Resistant Home
Module 5: Site Planning and Elevation
Module 6: Moisture Control Systems
Module 7: Wall Assemblies and Vapor Control
Module 8: Insulation and Energy Efficiency
Module 9: Roofing Contractors and Installation
Module 10: Problem Areas in Construction
Module 11: Window, Door, and Flooring Systems
Module 12: HVAC Systems
Module 13: Maintenance and Long-Term Prevention
Conclusion and Moving Forward
Lesson 5.3 – Foundation Elevation and Brick Ledge Construction
You need a membership to view the full content.
Already Enrolled?
Login to access the full content.
If you haven’t enrolled yet, click the Enroll Now link below to get started and gain full access.
Techniques for preventing water intrusion
One of the techniques I employ is increasing the height of the foundation reveal on the outside of the home beyond the normal codes. I prefer 10, rather than 6 inches, to be seen between the ground and the bottom of the siding, stucco, etc. This helps as the natural ground surrounding your home expands in the decades following the building process.
In addition to the taller foundation face, a designer can also call for a floor system that can help avert water problems up front.
There are two forms of floor system building:
- The floor structure is built on top of the foundation. This raises the house by the height of the floor joists. It is less expensive and is how homes are typically constructed.

- The floor structure is built within the foundation. This is created by adding a ledge inside the top edge the foundation, so the floor joists can sit down in the foundation rather than above it. This can help in reducing the overall height of the building, and increases the amount of waterproofed foundation on the exterior which greatly helps with drainage away from the home.
